Instruction manual

NOTICE: There is no warranty on kits. It is your responsibility to install the board and lights. Kits cannot be returned. This kit can

consume a lot of current. Be careful if you plan to use a battery source that is capable of delivering a lot of current. Contact a

professional if you need assistance. Hyperdyne Labs assumes no responsibility for the misuse of this kit. Night flying can be

dangerous. User accepts all liability of using this kit in their plane and the responsibility of flying at night.

Note the polarity of the cables so you can connect them properly to the other end (the

colors of the wire above may not be the same as in your kit).

Now take the gray 4-pin extension cable and solder the other ends of the long wing

ribbon cable to the 4 leads on the end of the gray cable. Solder the – wire from one wing

cluster to the gray lead that has a black stripe on the wire. Solder the + wire from that

wing cluster to the next lead on the gray cable.

Then solder the - wire from the 2

wing cluster to the next gray cable lead, and the +

wire from the 2

wing cluster to the last lead on the gray cable. The wires should be

hooked up as shown (they go - + - +, with the first wire being the black wire on the gray

cable).