Instruction manual

NOTICE: There is no warranty on kits. It is your responsibility to install the board and lights. Kits cannot be returned. This kit can
consume a lot of current. Be careful if you plan to use a battery source that is capable of delivering a lot of current. Contact a
professional if you need assistance. Hyperdyne Labs assumes no responsibility for the misuse of this kit. Night flying can be
dangerous. User accepts all liability of using this kit in their plane and the responsibility of flying at night.
7
Take 3 more red LEDs and do this again, so that you have 2 triangular wing LED
assemblies.
The wing LEDs will attach to the extra long 4-conductor ribbon cable included in the kit.
This then connects to the 4-pin gray extension cable.
First take the long 4-conductor ribbon cable piece and splice the wires on both ends.
Take one triangular red LED cluster and solder the unconnected + lead to one wire on
the ribbon cable, and the unconnected – lead to the other wire on the ribbon cable.
Take the other triangular cluster and solder the + lead and the – lead to the other 2 wires
on the ribbon cable.
+
_
+
_
+
_