Instruction manual

NOTICE: There is no warranty on kits. It is your responsibility to install the board and lights. Kits cannot be returned. This kit can
consume a lot of current. Be careful if you plan to use a battery source that is capable of delivering a lot of current. Contact a
professional if you need assistance. Hyperdyne Labs assumes no responsibility for the misuse of this kit. Night flying can be
dangerous. User accepts all liability of using this kit in their plane and the responsibility of flying at night.
25
entire session, but that means that you cannot easily tell when the receiver battery cutoff
will happen. Time your flights appropriately as to not put your plane or people in
jeopardy due to low battery cutoffs during night flights!
POWER CONSUMPTION
The light board uses a variable amount of amperage based on the battery pack you use.
Listed below are typical values for current consumption based on different battery
voltage configurations:
Light board in flight mode:
Battery config Batt voltage (V) Average light board
current (A)
Average light board
power (W)
7-cell NiMh 8.4 .200 1.7
8-cell NiMh 9.6 .260 2.5
9-cell NiMh 10.8 .340 3.7
11.1V 3S lipo 11.1 .360 4.0
Light board in extended flight mode:
Battery config Batt voltage (V) Average light board
current (A)
Average light board
power (W)
7-cell NiMh 8.4 .150 1.3
8-cell NiMh 9.6 .180 1.7
9-cell NiMh 10.8 .230 2.5
11.1V 3S lipo 11.1 .250 2.8
Take these figures into account when choosing a battery for your system. Flight times
can vary between 6-15 minutes at night based on your battery capacity, wind speed, and
your flying habits.
Enjoy your light kit and please be a safe and responsible night pilot!!