Instruction manual

NOTICE: There is no warranty on kits. It is your responsibility to install the board and lights. Kits cannot be returned. This kit can
consume a lot of current. Be careful if you plan to use a battery source that is capable of delivering a lot of current. Contact a
professional if you need assistance. Hyperdyne Labs assumes no responsibility for the misuse of this kit. Night flying can be
dangerous. User accepts all liability of using this kit in their plane and the responsibility of flying at night.
14
This LED comes on when you press the X-port button on your transmitter, so you have
some feedback that the circuit is working. It will also blink every 5 sec as a heartbeat.
For the wing clusters, take some packing tape and run the long ribbon cable on the
bottom of the wing. Tape down the ribbon cable as flat as possible.
You want the 2 parallel red LEDs to point forwards and backwards on the wing. You
want the other LED to bend up and point up to the top of the wing. This will allow you
to see your plane while banking with the top of the wing facing you. You can achieve
this by either punching a hole in the foam and running the LED to the top of the wing, or
install the wing cluster close to the end of the wing and simply bend the LED up. This
latter method is shown below:
Use packing tape to secure the wing clusters and cover up the exposed leads.
The last LED to install is the white front cluster. You can run the assembly through the
firewall into the cowl. It might be easier to unsolder the wires first so you can run the
wires through the motor wire holes through the engine firewall.
Install the cluster in the air vent on the cowl bottom. You can use hot glue to hold it in
place. The front cluster will allow you to see the front of your plane and aid in landing.
This cluster is very bright and compliments the wing tip LEDs for easy night landings!
NOTE: You want the LED cluster to point slightly downward so it is easier to see while
flying, and also will illuminate the ground during a landing.