Instruction manual

NOTICE: There is no warranty on kits. It is your responsibility to install the board and lights. Kits cannot be returned. This kit can
consume a lot of current. Be careful if you plan to use a battery source that is capable of delivering a lot of current. Contact a
professional if you need assistance. Hyperdyne Labs assumes no responsibility for the misuse of this kit. Night flying can be
dangerous. User accepts all liability of using this kit in their plane and the responsibility of flying at night.
10
YOU ARE NOW DONE CONNECTING UP THE LIGHTS!
Here is a picture of the main ribbon cable with all the LEDs and connectors soldered to
their respective ribbon cable wires (in order starting from brown and red wires).
KIT INSTALLATION
You are now ready to install the lights and the processor board into your Super Cub or
other R/C plane.
You can run the tail lights through the body. It might be easier to unsolder the tail LEDs
and run the wire through a small hole in the tail section. Then resolder the LEDs and
tape them down in between the vertical stabilizer as shown: