Instruction manual

Full frame start marking lamp
The full frame start marking lamp is to be found under a
cover plate (50) on which the film plane marking is also
engraved.
To replace the lamp, first remove both counter sunk screws.
When the magazine is removed the cover plate (50) can be
lightly pulled up so that the threads for the full frame start
marking lamp are visible.
With a special clamp the complete full frame start marking
lamp can be lifted out and replaced with a new one. The new
lamp must be securely positioned, the cover can then be
replaced. The lamps are long-term lamps and are operated
at below their rated voltage and so have a service life of
several hundred hours. A lamp change should be a seldom
occurrence.