Instruction manual

Camera speed switch 24/25 fps or 50/60 Hz
The switches are to be found in the camera base plate and
are visible when the magazine is removed (48). The
switches lie beneath the clear plastic cover (a). This allows
one to see if the camera is set for 24 or 25 fps or 50 or 60
Hz. To change over, remove the plastic cover and set as
required, then replace the cover. The switch over can, of
course, on)y be effected when the camera is switched off
and the battery disconnected from the camera.
Pilot tone output
On the left side of the rear base is the standard 5-pin pilot
tone output (44) for the standard ARRIFLEX pilot tone cable.
For all ARRIFLEX cameras there are standard pilot tone
cables.