Instruction manual

The pressure roller is then swung back and the film is
attached to the standard expansion film core (c) in the take-
up compartment - (see illustration). Holding the magazine
gear stationary, the film core is turned in the direction of the
engraved arrow (i.e. clockwise) until the film is taut; the
magazine gear is then released and the film core is turned a
full turn to ensure that the film is tightly gripped. Finally the
pressure roller is swung back into its position so that the
edges are in alignment with the film; the magazine cover
then is replaced and secured.
When a plastic film core is used, the standard film holder is
pushed onto the wind-up pole until it engages and the plastic
film core is then pushed onto it. The slit for fastening the film
must point with its pointed corner in the run direction. The
film-head should only be folded once (NOT several times)
and inserted into the film core slit; the film is then made taut
as described above.
When using daylight loading spools the film core holder is
removed, the film is fixed in the spool column outside of the
magazine, a small amount of film is wound up, the spool is
set in the magazine and the film is made taut. Unlike in the
instructions