Instruction manual

under the threading slot. .Film run in direction of the arrow
and the correct positioning of the perforations can only be
obtained when "B winding” film is used as previously
described.
The pressure roller (a) is then placed onto the film roll so that
the film roll is stabilized with the guiding edges; at the same
time It also operates the film supply indicator; Not for
daylight spools!
Slide the film head, which should be cut straight and through
the middle of a perforation hole, into the feed slot of the
magazine, turning the magazine gear slightly in the direction
of the arrow until a perforation hole is felt to be gripped; push
the film on until the film head reappears from the magazine
throat above the pressure plate. This operation can be made
lighter if the film head Is pushed into the feed slot before the
film roll or daylight loading spool is fixed to the feed shaft as
described above. The magazine lid is then shut and secured
by turning the hinged knob (32) to the right.
All further steps can be carried out in the light. The next step
is to pull the firm around the magazine until the loop length
marker is reached; the wind-up magazine cover (13) is
released and opened up and