Instruction manual

Loading the magazine
The film must be threaded with the emulsion inwards. With
single perforated film care must be taken that only "winding
B" film is used.
To load the film, the magazine lid on the film supply side (35)
must be unlocked and swung open and the pressure roller
(a) must be swung back until it engages. The magazine must
be loaded in a dark room or in a film changing bag.
When using raw stock on plastic cores the film core holder
(g) is put on the feed shaft, the film roll with the core is
pushed onto the film core holder and secured by swinging
the flap back and tightening it. Daylight loading spools are
placed directly on the feed shaft and also secured.
CARE! Should self-wound rolls be used (e.g. a part of a
larger roll of raw stock) do not fold the film end over before
placing it in the slit of the plastic core as it may jam in the
magazine throat or film channel and cause damage.
The film head must always run in the direction of the arrow.
Single perforated film is threaded with the perforation to the
outside, as shown by the symbol