User Manual

Module Specification
NO. AT2530
TITLE:
Module, ZigBee, 14.9 x 21.9 x 2.65mm, 45 I/O, Edge Castellated, SMD
REVISION DATE: 22 May 2013 ISSUE: O PAGE: 18 of 19
7.6 OEM Labeling Requirements
1. The CE conformity marking must consist of the initials CE taking the following form:
If the CE conformity marking is reduced or enlarged the proportions given in the above
graduated drawing must be respected
2. Where the directive concerned does not impose specific dimensions, the CE marking
must have a height of at least 5 mm.
3. The CE marking must be affixed to the product or to its data plate. However, where
this is not possible or not warranted on account of the nature of the product, it must be
affixed to the packaging, if any, and to the accompanying documents, where the
directive concerned provides for such documents.
4. The CE marking must be affixed visibly, legibly and indelibly.
For more information please refer to http://ec.europa.eu/enterprise/faq/ce-mark.htm.
Customers assume full responsibility for learning and meeting the required guidelines for
each country in their distribution market.
7.7 CE Compliance Power Settings
The following antenna has been tested and approved for use with the AT357 Module:
- Dipole (2.5dBi, AAC part number A.01.120)
Table 16 shows approved channels of operations with the corresponding maximum
output power steps settings.