Instruction Manual
INSTRUGnON
MANUAL
Industrial Triplex Pumps
INDUSTRIAL
TRIPLEX
PUMPS
5. Refill
pump
using
SIMPSQNCII
Premium Pump Crankcase Oil. If
this oil is not available, an SAE
15W-40 oil may be used.
6. Replace pump oil fill plug and
tighten
securely.
CLEAN
THE
WATER
INLET
FILTER
This screen filter should
be
checked
periodically and cleaned
if
necessary.
1. Remove
filter by grasping end
and removing
it
from water inlet
of
pump.
2. Clean filter
by
flushing it with water
on both sides.
3. Re-insert
filter into water inlet
of
pump.
NOTE:
Convex side faces
out.
NOTE: Do not operate the pressure
washer without
filter properly installed.
STORAGE
The manufacturer recommends using
SIMPSON• I POWERWASHERI Pump
Guard (part
#80130)
or
equivalent
when storing the unit for more
than
30 days and/or when freezing
temperatures are expected.
SIMPSON•
I POWERWASHERI Pump Guard
is
environmentally friendly.
NOTE: Using pump guard helps provide
proper
lubrication
to
the internal seals
of
the pump regardless
of
temperature
or
environment.
NOTICE: Risk
of
property damage.
Use
only SIMPSOf'./8 I
POWERWASHE~
Pump Guard
or
equivalent. Other
products could
be
corrosive and/or
contain alcohol which may
cause
pump
damage.
1. Turn
off
pressure washer and
disconnect hoses from pump.
2. Unscrew bottle valve from Pump
Guard
bottle and remove seal.
3. Screw bottle valve back
onto
bottle.
4. Attach bottle
to
water inlet
of
pump.
5. Squeeze bottle
to
inject contents
into pump.
6.
With
ignition
switch
off,
simultaneously pull starter rope
and squeeze
bottle. Repeat until
protector fluid exits pump outlet.
NOTE:
This step may require
two
people.
LIMilED
WARRANTY
The
manufacturer
of
this product
agrees
to repair
or
replace designated parts
that prove
defective within the warranty
period
listed below at the manufacturer's
sole discretion. Specific limitations/
extensions
and
exclusions
apply.
This warranty covers defects
in
material
and workmanship
and
not parts failure
due
to
normal
wear,
depreciation,
abuse,
accidental
damage,
negligence,
improper
use,
maintenance, water quality
or
storage.
To
make
a claim under the
terms
of
the warranty,
all
parts said to
be
defective must
be
retained and available
for return upon request
to
a designated
Warranty Service Center for warranty
inspection.
The
judgments and decisions
of
the manufacturer concerning the
validity
of
warranty claims are
final.
These
warranties
pass
through to the
end user and
are
non-transferable.
As
a
factory authorized and trained Warranty
Service
Center,
the factory will honor the
terms of
all
component warranties
and
satisfy claims
of
the appropriate warranty
provisions.
Normal
wear items include, but
are
not
limited to, valves and
seals,
which
are
not
covered by this
warranty.
This warranty replaces all other
warranties, express or
implied, including
without limitation any warranties
of
merchantability or fitness for a particular
purpose and all such warranties
are
hereby disclaimed and excluded by
the manufacturer.
The
manufacturer's
warranty
obligation is limited
to
repair
4-
ENG
140*213MM