Instructions for use

« Nim-Mh / Ni-cd » battery program
This program allows you to charge / discharge your Ni-xx batteries. The work principles are the same for Ni-Mh and Ni-Cd, only the delta Peak
values are different following the program you choose. Please make sure to attach the matching batteries (Ni-Mh or Ni-Cd) when using one or
the other program.
Charge
This function allows you to charge your Ni-xx battery. Just indicate the maximum charge current, and launch the
charge process. End of charge will be detected depending of the delta Peak values entered in the “User Set Program”
-> “Ni-xx sensitivity”.
Cycle
This function allows you to cycle your batteries to bring them back to their optimal performances, or to get rid of
the “memory effect” of the battery. Nickel batteries develop a memory effect when they are not used / discharged at
their maximum capacity. After some time, they memorize the capacity requested during the last operations and will
behave as if they had that capacity as a maximum. Cycling them from time to time will allow them to recover their
full performances. You can select the number of cycles ( from one up to 5), and you can check the current drawn
or charged on the screen once the process launched.
Discharge
This functions allows you to discharge your battery with a current between 0.1 Ah and 1Ah, and a discharge
voltage limit between 0.1 and 25 Volts. The voltage you will input must match the voltage of the battery pack, not
the voltage of a single cell ( expect if you connect a single cell to the charger).