Owner`s manual

owner's manual

4.4 Installing the pedals

1. Lightly coat the threads of the pedal axle with light

grease. This will make screwing the pedal into the crank

arm easier, and will help prevent corrosion in the future.

2. Two pedals (a left pedal and a right pedal) are supplied.

Each pedal is DIFFERENT. There is an 'R' stamped on the

spindle of the right-hand pedal, and there is an 'L' stamped

on the spindle of the left-hand pedal.

3. Install the right pedal on the right-hand side, and the left

pedal on the left-hand side. It is very important that each

pedal is installed on the correct side.

CAUTION: Attempting to screw the left pedal into the right

crank arm (or vice versa) will damage the internal threads

of the crank arm. This damage is not ‘xable’ and the

crank arm will have to be replaced.

4. When installing the right pedal, screw the threaded

section of the pedal spindle into the crank arm turning the

spindle in a CLOCKWISE direction.

5. When installing the left pedal, screw the threaded

section of the pedal spindle into the crank arm turning the

spindle in a ANTI-CLOCKWISE direction.

6. Screw each pedal as far as you can into the crank arm

with your ngers.

7. Using a 15 mm open end spanner, securely tighten

the pedals.

8. Ensure the pedals are installed with a torque value

of 30 Nm.

An improperly installed pedal may fall off your A2B

whilst in use. This may cause an accident resulting in serious

injury or death and property damage. Ensure that your

pedals are properly installed and tight before each ride.