Operating instructions

This section describes how to make a quick installation following the step by

step instructions below. See to that the control software files delivered on the

CD-ROM are loaded into the PALM. For more information on how this is

done, please consult your PALM user manual.

1. Connect the module (EFTA1-T2 or ETA-100) to a DC power supply (the

ESP-100 or EPP-100). Then connect your PALM PDA to the module with a

PALM Hotsync cable to the RS-232 serial port on the front of the module.

2. Tap the EFTA or ETA icon in the A2B Control menu of the PALM.

3. A Welcome menu should appear if your PALM is in contact with the

module. Click [Next].

4. Settings with PALM PDA

English