Operating instructions

12
English
Below you find description of the different settings in the main menu.
1. RECEIVER
Channels can be selected if CCIR channel table is used. For other channel
tables the corresponding frequency should be entered. Enter also the channel
bandwidth and check that the Eb/No reading shows a value higher than 20. If
reading is lower, check and adjust the antenna installation. Enter [Program
receiver] to program the values to the EFTA1-T2 or the ETA-100.
2. DECODER
The [Service] menu allows you to choose a program from the chosen
Multiplex. Enter also audio and subtitling languages.
3. AUDIO/VIDEO
The video menu allows for setting of transmission standard, picture aspect
ratio (4:3, 16:9 or combined 14:9). [WSS] stands for Wide Screen Signalling
and is a signal that is available in the video and signals to each TV-set which
aspect ratio the TV-set should display. This is done automatically by most TV-
sets. In the [Teletext] menu teletext or DVB-subtitling can be selected or
disabled. [Audio] menu allows setting of audio output level and mode (mono,
stereo).
4. CA SETTINGS (ETA-100 only)
Information about CA module and embedded CA system can be done in this
menu. Appropriate smart cards needs to be inserted into the corresponding
slots.
5. SYSTEM SETTINGS
Set regional settings in this menu. Serial port can also be changed in this menu.
6. FIRMWARE
Click [Firmware] if a new software is available for your ETA-100 or
EFTA1-T2. Entering this menu you can browse your folders for the correct
download file and download the new software into the ETA-100 or the
EFTA1-T2.
7. [i] and [?]
Information and help menus that can be used for details of how to install and
make settings. The [?] menu will be accessible on later software revisions.