Specifications

5151
This specification may change without prior notice.
Connectors and Interfaces
Control and IP out connector RJ-45, 10/100 BaseT
RF input connector F female, 75 Ω
RF output connector F female, 75 Ω
ASI input connector BNC female, 75 Ω
ASI output connector BNC female, 75 Ω
CAM connector PCMCIA (5 VDC)
LED Indicator lights Power on, Rx error,
Tx/Access error
SNMP Interface RJ-45, 10/100 BaseT
A/V out connector 3,5 mm 4 pole
QPSK/8PSK Satellite Receiver ESX-200
Input Frequency 950 – 2150 MHz
Input Level -65 to -25 dBm
Input impedance 75 Ω
Spectral inversion Yes, Auto for C-band LNB
LNB voltage Auto, Off or 13/18V
programmable.
Max. 400 mA. (short
circuit protected)
22kHz to LNB Auto, On or Off
programmable
DiSEqC 1.1 Yes, 4 port switch
Max input TS bit rate > 60 Mbit/s DVB-S, DVB-S2
DVB compliance DVB-S (EN 310 421)
DVB-S2 (EN 312 317)
RF Modulation (analogue)
Standards B/G, I, D/K, L, M/N
Sound Mono, NICAM stereo or
A2/A2* stereo
Modulation video VSB AM, neg. or pos.
Modulation mono Audio FM or AM
Output frequency 47 – 862 MHz (1 kHz step)
Output level > 110 dBuV (47-470 MHz)
> 105 dBuV (470-862 MHz)
S/N weighted > 57 dB
C/N, broadband > 70 dB
NICAM standards NICAM 728 (EN 310 163)
Power ratio B/G -20dB,
(Vision/NICAM carrier) I -24dB,
D/K -24dB,
L -31dB
Tolerance +/- 1dB
Impedance 75 Ω
QAM modes 16, 32, 64, 128 and 256 QAM
Symbol rate 4 – 7.2 Mbaud/s
MER (at RF out) > 38 dB for 256-QAM
DVB compliance DVB-C (EN 310 429)
QAM output frequency 47 - 862 MHz (1 kHz step)
Output level Min 105 dBuV (47-470 MHz)
Min 100 dBuV (470-862 MHz)
PSI/SI management Yes
Remultiplexing Yes
QAM modulation (SW Option)
11 Technical specification EXM
English
COFDM modulation (SW Option)
COFDM Terrestrial Receiver ETX-200
Input frequency 50 - 858 MHz (centre freq.)
Input freq step size 250 kHz
Input level range -60 to -31 dBm *)
Input impedance 75 Ω
Input return loss 12 dB
C/N limit 18 dB *)
Bandwidth 6/7/8 MHz
DVB compliance DVB-T
Co/adj channel PAL Compliant to Nordig 2 PAL
Automatic mode change
recovery Yes
Echo performance Compliant to Nordig 2 unified
*) QEF reception with test signal: 8k, 64QAM, 1/8 guard
interval, 2/3 FEC
QAM Cable Receiver ECX-200
Input frequency 50 - 858 MHz (centre freq.)
Input freq step size 250 kHz
Input level range -55 to -25 dBm *)
Input impedance 75 Ω
Input return loss 12 dB
QAM mode 16, 32, 64, 128 or 256 QAM
Baud rates 3100 to 7000 kS/s
C/N limit 26 dB *)
Bandwidth 8 MHz
DVB compliance DVB-C
*) QEF reception with test signal: 64QAM, 26 dB C/N
COFDM mode 2K
Guard interval ¼, 1/8, 1/16 or 1/32
FEC 5/6 or 7/8
MER >32 dB
DVB compliance DVB-T (EN 310 744)
Max output bit rate 26,92 Mbit/s (8 MHz bandwidth)
23,55 Mbit/s (7 MHz bandwidth)
20,19 Mbit/s (6 MHz bandwidth)
Output frequency 47 – 862 MHz (1 kHz step)
Output level Min 100 dBuV (47-470 MHz)
Min 95 dBuV (470-862 MHz)
PSI/SI management Yes
Remultiplexing Yes