Specifications

English

5 Menus and settings (continued)

5.2.b Input settings, ETX-200

Select the bandwith of the channel you want to receive. Next select the channel

number according to CCIR or enter the correct frequency (in MHz). Be sure to press

[Set] to enter the frequency to the ETX-200.

A list of the available services from the multiplex you tuned to, will be shown on the

right hand side.

Below [Tuner settings] information of the received signal is displayed.

If only ”ASI in” is used you can ”Disable” the tuner at [Input source].

We suggest that you consult your local terrestrial operator for correct parameters for

each multiplex you want to receive.

Note! We recommend that the [Level] reading is between

-31dBm to -55 dBm and C/N better than 25 dB for best performance.