Installation guide

99
IP address settings (continued)
Setting new static IP address in
the ECX-200
Connect your PC to each EXM
unit after that you have done all
other settings in the units and
change to a specific IP address
for every unit.
A recommendation is to use from
192.168.0.21 and higher.
NOTE! Almost every switch/router use
192.168.0.1 as default IP address so
make sure you don’t use the same IP
address in any ECX-200 unit.
To continue settings press [Input]
4.3.3 Tuner settings
Select [Modulation], [Symbol rate]
and the [Channel name] or enter
the [Transponder frequency] (in
MHz).
Press [Set] to save settings.
A list of the available services
from the multiplex you tuned to,
will be shown on the right hand
side and also available services
via the ASI input.
Below [Tuner settings] information
of the received signal is displayed.
Note! We recommend that the
input level is better than -45dBm
and that the C/N is better than 36
dB (QAM64).
4 Settings (continued)
English