Installation guide

88
4.3 EXM Web Control Interface
4.3.1 System menu
The following [System] menu
should appear when you connect
to the ECX-200. The [System]
menu contains basic information
about current settings and SW
options.
Menu buttons for [Input],
[Output], [IPTV], [Service
management], [CI] and [Upload]
are available at the top of the
menu.
NOTE! [IPTV] needs a SW option
to be available
4.3.2 IP address settings
The ECX-200 is set to an default IP address from factory (192.168.0.20 ). However, it
is possible to change the IP address and/or the Netmask and/or the Gateway. This is
an important function when you install two or more EXM units in a Head End and
want to connect all units together through a switch or a router.
4 Settings (continued)
English
Current settings
Contains information of current input and output signals, if the tuner is
locked to a signal, firmware version, bootloader version, hardware revision and
serial number.
Software options
Show what software options that are available in this unit (e.g. output
signal format, input signal etc.) See section 7 for more information.
System options
This menu contains current IP settings for the ECX-200.
[Reset unit] gives a possibility to restart the unit at any time.
[System diagnostic]
By a click on the ”Download diagnostic file” you can save a file that you
can email to [e-mail] for analysis if there is a problem with a unit.