Installation guide

3131
MPEG Decoder - Audio
Supported formats MPEG 1 layer II, AAC HE,
Output Selection of Dual mono in,
Stereo or Mono
Impedance < 100 Ω
Output level 0 dBu
Level adjustment +3 to -9dB
MPEG Decoder - Video
Graphical User Interface (GUI)
English
ASI bit rate 270 Mbit/s
Max payload bitrates:
Input bit rate 55 Mbit/s *)
Output bit rate 55 Mbit/s *)
PCR restamping Yes
PSI/SI management Yes
Remultiplexing Yes
*) The input, output and throughput bitrate is highly
dependent on the type of application that is running in
the unit.
ASI input (SW option) – output
Graphical User Interface for easy set up of complex
systems. Simple handling of remultiplexing
and creation of new multiplexes from any input.
Default settings of PSI/SI tables to avoid clashes in the output
multiplexes.
Simple structure for setting input, output and processing
parameters.
Each ECX-200 contains an embedded web server.
Standard web browsers (Internet Explorer 8, Mozilla Firefox etc.)
are supported.
With FW 1.22 (or later) in your ECX-200 you also can use a third
party program for surveillance via the SNMP interface.
Supported formats MPEG2 MP@ML, MPEG4 H.264 AVC
Output standards PAL, SECAM or NTSC
Impedance 75 Ω
Output level 1 Vpp @ 75 Ω
Aspect Ratio Letterbox, Pan/Scan,
or conversion Combined (14:9)
programmable, WSS
Teletext Insertion in VBI
Subtitling Teletext or DVB subtitling
Decryption Common Interface (PCMCIA 5VDC)
Multidecryption Yes *)
*) SW option is needed
Each ECX-200 contains a remultiplexer for 2 incoming transport
streams. The transports streams can be received from cable and from
the ASI input. PID remapping is made automatically.
The following components can be remultiplexed:
Audio, Video, Subtitling, PAT, PMT, NIT actual, EIT, CAT,
SDT, TDT and TOT.
IP connection between EXM units in a system is required for NIT, EIT
other and SDT other.
Remultiplexing (SW option)
This specification may change without prior notice.