Installation guide

1616
4 Settings (continued)
English
4.2.6 IPTV output (SW option)
This menu allows for settings
required to transmit a digital-TV
transport stream as IPTV. IPTV
output is optional and can be
ordered separately as a SW option
(see chapter 7, SW Options).
For IPTV out you have to set [UDP/RTP] values for Port and Address, e.g.: IP
address 239.192.0.10 and Port 1234. In the ”Bitrate” box you can choose bitrate
for the IPTV TS out. The maximum value is 55Mb/s. Click [Set bitrate] to save
settings. Click [Start] to start IPTV streaming on the output (RJ 45 connector). To
check the IPTV out signal, use VLC Player or similar.
4.2.7 CI and Smart card information
This menu allows you to view
information about your CA-system
and current subscriptions etc.
There is also an [Advanced settings]
menu, but we recommend to NOT
change in this menu if you are not
aware of what the effect will be.
If you by mistake have changed any
setting you can always click on the
”Reset button” to come back to
Default settings.
NOTE! To avoid overload it’s not recommended to run other RF
output at the same time as IPTV out e.g. choose ASI as
Output. The choosen bitrate will be the same on the ASI output