Installation guide

1414
4 Settings (continued)
English
In the menu section Available
services all services the unit
receives, both from the [Tuner input]
and from the [ASI input], are listed.
To select the service or services you
want as output, mark services under
[Available services] by clicking the
line where the service is presented
and then click the “Set digital” button.
A “X” should appear in the “Dig”
column. Do the same to choose a
service as “Analogue out”. Make your
choice of which services you want to
select as outputs and you will see the
selected service(s) in the [Digital
output] list in the menu.
The ASI output automatically contains the services you have selected for [Digital
output].
For decryption you mark the service by clicking the service name in the [Available
services] list and by clicking on “Enable” under the [Decryption] headline.
NOTE! To decrypt more than one service requires a multidecryption CA module and a
smartcard that is activated for more than one service. Some smartcards can handle
three or more services at a time. Please refer to your smartcard service provider and or
program provider for further information.
Network settings
Click the [Network settings] button to display the Network settings menu. Here you can
write [Network Provider Name], [Network ID], [Original Network ID], [TransportStream
ID] and select [Logical channel type]. When one or more choices has been made, you
have to click on [Save] to store your settings. The DVB standard recommends following
Network ID ranges:
DVB-S: 0 to 8191 (0 should be avoided)
DVB-T: 8193 to 13568(Boxer in Sweden use 8945)
DVB-C: 40961 to 65281 (ComHem in Sweden use 41001 and up)
To make Network search to work on STB:s (Set Top Boxes) that are connected to the
cable TV network you must have all EXM units interconnected to a switch and also
assure that the Original network ID and the Network ID is set to the same value in all
EXM units.