Installation guide

1313
4 Settings (continued)
English
COFDM mode (SW option)
For [COFDM] (DVB-T) output you
can select Output channel (E2 to
E69) or Frequency and Output
signal attenuation (0 to -31dB).
You can also select bandwidth (6,7
or 8 MHz). For max recommended
output bitrate see page 17.
Click [Set] to save settings.
COFDM modulation settings are
2k, 64QAM, FEC 7/8, GI 1/32
Click [Service management] to
select service(s) and or create new
multiplexes.
4.3.5 Service Management
The Service management menu
gives an overview of available
services from satellite or the ASI
input (if enabled). Remultiplexing
(remuxing) is possible after
downloading an appropriate SW
option. To build your own MUX you
combine several incoming services.
These can be received either from
the tuner or from the ASI in. Under
the [Digital output] section in this
menu you can see the actual
(instantaneous) “Outgoing data rate”
and the “Configured data rate”. This
helps you to avoid overload for the
output (see page 17 for information).
From FW 1.23 there is also logging
of Output bit rate in the SNMP (see
page 29)
NOTE! When a service is selected
as Analogue output only, a web reset
or a power reset is necessary , to
start decoding of the selected
service.