DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 1 of 9 Product Specification Product Name: Model: Lithium-ion battery HTPFR18650-1100mAh-3.2V Make By: MeiQinghu Checked By: Zhou Hui Approved By: Li Tao Shandong Goldencell Electronics Technology Co.,Ltd Headquarter Branch office (Shenzhen) Add: 603,6/F.,PolyU Base Bldg.,Yuexing Road, Hi-tech Industrial Park, Nanshan,Shenzhen, China Add：Thailand Industrial Park, Hi-tech District, Zaozhuang City, Shandong Province, China.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 2 of 9 Contents 1. Application Scope........................................................................................................ 3 2. Model........................................................................................................................... 3 3. Appearance and Dimension......................................................................................... 3 4. Major Technical Parameters............
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 3 of 9 1. Application Scope This product specification describes product performance indicators of Lithium-ion battery produced by Shandong Goldencell Electronics Technology Co.,Ltd 2. Model HTPFR18650-1100mAh-3.2V 3. Appearance and Dimension Item Dimension (mm) H 65.2±0.3 Ф1 8.85±0.15 Ф2 10±0.2 Ф3 18.2±0.1 Sleeving PET or kraft paper 4. Major Technical Parameters No.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： R1.0 PAGE： 4 5. Characteristics Curves 18650-1100mAh-3.2V Charge-Discharge curves（0.5C） 4 Voltage/V 3.5 Charge Discharge 3 2.5 2 1.5 0 200 400 600 800 Capacity/mAh 1000 1200 Voltage/V 18650-1100mAh-3.2V Discharge curves at different rates 1C 3C 5C 10C 15C 20C 30C 3.6 3.3 3 2.7 2.4 2.1 1.8 1.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 5 of 9 100%DOD 6. Safety Characteristics NO. Item 1 Overcharge 2 Over Discharge 3 External Short-circuit Test Method Standard After normal charge, test the batteries’ initial state and capacity. Charge to 10.0V at 3C, then charge at CV mode to 0.01C. No explosion, No fire. Observe battery’s variation of appearance. After normal charge, test the batteries’ initial state. When the batteries are normal, Discharge to 0V at 0.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： 8 Use Φ3 mm to 5 mm high temperature resistant steel needle, to 10 mm/s ~ 40 mm/s of speed, from the perpendicular to the direction of the battery plate(Steel needle stops in the battery). Prick test R1.0 6 of 9 No explosion, No fire. 7. Environmental Adaptability NO.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 7 of 9 9. Storage and Others 9.1 Long Time Storage If the battery is stored for a long time (more than three months),the battery should be stored in dry and cool place. The battery should be charged and discharged every there months. The batteries’ storage voltage should be 3.3~3.4V and the battery should be stored in a condition as NO.8. 9.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 8 of 9 Appendix A Suggestions for Battery Packs 1、Selecting principle of nickel strip is often applied to the design of battery packs. Based on the working current of battery packs to make the shunt selection of nickel strip. The common nickel strip could under the current as below: Nickel Strip Type 3*0.1 4*0.1 7*0.15 8*0.
DOC NO：SDJG/C- LI-PS201 Lithium-ion Battery Series REV ： PAGE： R1.0 9 of 9 3 、 Voltage protection point value (for single cell ) of protection board or BMS, and selecting principle of protection board. The protection voltage point for monomer should be selected also based on Lithium Iron the safety voltage point of 3.6-3.9 2.0-2.5 Phosphate cell and protection voltage point of IC. Ni-Co- Mn 4.05-4.25 2.5-3.
