User's Manual

76 User Manual
North American compliance information applies only to the North American Regional Variant
of this product. This product is not authorised to be used in a region for which it was not intended.
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be required
to correct the interference at his own expense.
3. Regulatory and compliance information - North America
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This product complies with FCC radiation exposure limits
set forth for an uncontrolled environment. The equipment
should be installed and operated with minimum distance
of 20cm between the Antennas and your body.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful
communication.
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
This device may not cause interference. This device
must accept any interference, including interference
that may cause undesired operation of the device.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada.
EU compliance statement
Conek hereby declares that this wireless device is
in compliance with the essential requirements and
other relevant provisions of the Radio Equipment
Directive (RED). A copy of the EU declaration of
conformity for Conek Gateway is available at
www.asafe.com
European compliance information applies only to the European Regional Variant of this product.
This product is not authorised to be used in a region for which it was not intended.
This device may be operated in all member states
of the EU. Observe national and local regulations
where the device may be used.
Important
Changes or modifications to this product
not authorised by Conek could void the
electromagnetic compatibility (EMC) and wireless
compliance and negate your authority to operate
the product.
Disposal and recycling information
This symbol on the device and or
the packaging, indicates that the
device should not be disposed of as
general waste. Gateway should not
be disposed of as unsorted municipal
waste and should be taken to a
certified collection point for recycling
or proper disposal.
Disposal of the device is subject to WEEE Directive
Recast (Directive 2012/19/EU). The purpose of
separating WEEE from other waste is to minimise
the potential environmental impacts and human
health risk of any hazardous substances that may
be present.
Reduction of hazardous substances
This device is compliant with RoHS Directive
Recast (Directive 2011/65/EU).
3. Regulatory and compliance information - Europe