Operation Manual

3.9.5.1 Compass
TEASI PRO & TEASI ONE
3
X
The compass screen shows the built-in compass of the device.
Recalibration is also possible by pressing the ‘Start’ button under
‘Calibration’.
When compass calibration is started,
sweep the device through a figure 8
pattern to calibrate the compass.
During sweep, also rotate the device
so its screen is faced to the center of
the movement.
The device signals, if the calibration was successful or not.
Note: The compass calibration might not succeed at the first attempt.
Please, try to repeat the operation whenever you have the impression
that the compass is not orientated correctly.
3.9.5.2 Barometer
The built-in Barometer sensor is used to provide you information
about the altitude variations during your activity.
This sensor needs to be calibrated, setting an initial altitude value
that might come from the GPS or it can be set manually, if you know
the exact altitude of the place where you are.
When the sensor is calibrated, ‘Calibrated’ text will notify you.
Recalibration can be achieved by pressing the ‘Reset button’.
Note: Any change to the weather means a change to the air pressure,
which can lead to a change to the current altitude. The reference value
in the barometer settings is used every time the user switches the Teasi
on, which means the barometer must be recalibrated every time after
Teasi has been turned off then on, or position has been changed.
If you want to enter the altitude manually, select ‘Manual’, then press the height button
(default: ‘0m’) and insert the desired value.