Operation Manual

3.1.3 Recursive Height Analysis (RHA)
TEASI VOLT & TEASI VOLT BT
Teasi Volt uses Recursive Height Analysis (RHA) for accurate E-Bike
range calculation and display.
In this way, the areas that can be reached with current battery level are
presented on map screen.
The area covered by the RHA darkens as getting further from current
location. These areas can also be reached, however more battery will
be drained during the process.
Locations outside the RHA area cannot be reached with the current
charge available in the battery and the current assist level in use.
RHA calculation can be turned on ( ) or can be turned off ( )
inside the Map Screen.
Calculation of RHA area is also indicated on this button, when calculation is over, the RHA layer is
displayed.
3.1.4 Suggested Assist Level Popup
When current assist level is too high, based on battery capacity and remaining distance to
destination, Teasi Volt will notify about this problem and offer a new assist level that is calculated
to be sufficient for finishing the route.
Warning to lower assist level for reaching destination.
If there is no assist level that lets the user
finish the route, a recalculation will be started
for a route that can be finished with currently
remaining battery level.
If there is no possible route that can be
completed with the current battery level, the
application will warn:
‘Not enough battery power to reach the destination.
You still have power for the next X km/miles at the lowest assist level’
where X is calculated based on the current available battery.