Operation Manual

When paired, profile is in use and bike is connected, or Teasi
changed to the correct profile, Teasi will inform in a pop-up.
E-Bike connected and functioning correctly:
This pop-up can be dismissed by pressing ‘OK’, or it is dismissed
automatically after 10 seconds.
2.5.2 Troubleshooting for E-Bikes with Brose systems
In some cases, it may happen that the Teasi Volt is unable to connect with an E-Bike, building Brose
systems, especially if the Teasi Volt is connected before the bike is turned on.
E-Bike connection was not successful:
The problem usually can be recognized, because the bike lamp is starting to flash with high
frequency when the connection should be established.
In this case, please:
1. Remove Teasi Volt from cradle.
2. Power off Brose bicycle by long pressing the Power button on battery unit.
3. Power on Brose bicycle by pressing the Power button on battery unit.
4. Put Teasi Volt back on Brose bike.
5. Connection should be set up successfully.