Installation Instructions

Installation and Service Manual Upsilon-Series

Set time

00:00

Good

we 10:17

DD-MM-YY

01-01-00

9.3 Commissioning

Turn the electrical supply on (heating system does not have to be lled);

During start-up, a blue screen is displayed:

NC Power Up (= start-up screen)

Please wait (under certain circumstances)

Then you see: Address (= allocation of boiler address)

In the case of a cascade installation: Select the correct address and press OK

Select for the rst boiler 01 (=Master), for the next 02, 03 etc (=Slave)

The address can be changed by pushing the + button (increase value) and the – button

(decrease value). Once the + or – buttons has been pushed, the value starts ashing.

In the case of a single boiler: Conrm address 01 by OK

The display shows: Time Set (= setting actual time)

00:00

Setting time and day is only required on the Master-boiler. The Slave-boiler will take the

time and day settings automatically.

First set the hours using + and -.

Press the "right arrow” button to move to the minutes.

Set the minutes using + and -.

Conrm by OK

The display shows: DD-MM-YY (= setting actual date)

01-01-00

Change the settings using the + and – button. Jump from DD to MM and YY using the

arrow button.

After conrmation by OK and after the automatic de-aeration programm has ended,

you will see the standard read-out “Good” showing the date and the time after the de-

aerating program.

Standard read-out: Good

we 10:17

Good indicates that the boiler operates normally (burner on or off)

wo 10:17 indicates the actual day and time.

Following a restart (after loss of power):

Following a brief loss of power, the control will start-up as described above, but all set-

tings are retained.

In the case of a loss of power lasting more than 2 hours the time and date has to be

setted again. All other settings are retained.

If the water pressure is below 1.0 bar, the screen will show: FILL. Please refer to the

chapter Filling CH-system.

Address

-- NC --

Power Up