Installation Instructions

Installation and Service Manual Upsilon-Series

5.2 Free-standinginline

A . Position the pipe work header in the required location. When using several pipe work

headers: couple the pipe work headers using the supplied gaskets, M12 (DN65) or

M16 (DN100) bolts, spring washers and nuts. Align the pipe work header(s) horizon-

tally using the adjustable feet.

B. Place the gas line in its intended recess. When using several pipe work headers:

couple the gas lines using the supplied DN50/DN65 gaskets, M12 bolts, spring

washers and nuts. Refer to gure 5.2.b.

 Fastenthegaslinewiththe2specialclosetoleranceboltsM6x8x16oneach

angeofthepipeworkheader(s).Refertogure5.2.c.

C. Fit the I-columns on the ange plate using 2x bolts M8x40x70mm.

Attention:Usethecorrectholesinthecolumn!

 Whenusingaleftangeplate:usetheright-handholesinthecolumn.

 Whenusingaright-handangeplate:usetheleft-handholesinthecolumn.

D. Fit a mounting frame on the I-column using 3-x bolt M8x50mm. Refer to gure 5.2.e.

Attention:mountingrailatthetop.

E. Fit a mounting frame on the other I-column using 3-x bolt M8x50mm. Refer to gure

5.2.f.

If boilers also have to be tted on the other side of the I-column, then the next moun-

ting frame also has to be tted straight on it.

F. Fit the remaining I-column(s) between the mounting frames using 3x M8x50mm.

Refer to gure 5.2.f.

G. Hang the boilers on the mounting rail.

 Lifttheboileronlybythespecialgripsonthebottompanel(1)andsupport

theboilerbyitsrearpanel(2).Refertogure5.2.g.

Continue with chapter 5.4

Figure 5.2.a

Figure 5.2.b

Figure 5.2.c

Figure 5.2.d

Figure 5.2.e

Figure 5.2.f

Figure 5.2.g

Liftingandcarryingprecautions:

- Lift only a manageable weight, or ask for help.

- When lifting the boiler, bend the knees, and keep the back straight and feet apart.

- Do not lift and twist at the same time.

- Lift and carry the boiler close to the body.

- Wear protective clothing and gloves to protect from any sharp edges.