User guide

Installation Instructions

Caution:

• Once the mounting, plumbing, power connection and water filling is done, then only

the power supply should be given. The steps need to be followed as per the user

guide.

• This water heater is heavy, hence will require at least 2 persons to carry and install,

otherwise it may cause injury.

• Please carry the water heater in the ex-factory state and do not tilt over 45°C angle or

vertical placing.

• Disassembly and assembly by users is prohibited.

Mounting

This water heater should be installed at a location that is close to power socket, floor drain and

water utilisation point. As the outlet of the relief valve might discharge water during the

operation of the water heater, therefore the floor drain should be provided near the water

heater. In the installation area, it should be ensured that the water leakage of the water heater

or pipeline joints should not cause damage to the articles in adjacent region or lower layer of

the building. While installing the water heater, please be sure for mounting the water inlet and

outlet pipes at the bottom of the water heater.

Vertical installation of the water heater is strictly prohibited.

Mounting procedures and precautions

The installing surface must be capable of supporting at least four times the weight of the water

heater when filled with water. If the water heater is not installed on the bearing wall or is

mounted on hollow brick wall, corresponding protective measures must be provided, for

example supporting rack, through-wall screw, mounting of back plate, etc.

Prior to confirming the positions of bolt holes, retain at least 300 mm space on the right side of

the water heater, to open the side cover for repair.

• If the water heater is embedded into a gusset plate, the plate on the right side should be

moveable for convenience to dismantle the end cover for repair and maintenance.

• The water heater should not be located outdoors or in an area subject to freezing

environment. If freezing occurs, the container and water pipe will break, causing scald or

leakage.

Caution:

• water heater

• The water heater should be hung until the accessories are fixed firmly or else the

heater may fall off and serious injury accident might be caused.

• The maximum power of this water heater is 3000 W, hence a single dedicated power

supply circuit is proposed, the core area of electric supply wire should not be less than

2.5 mm .

This should be installed with the fixing accessories provided.

Caution: Hot water over 50°C will cause scald. In order to protect you and your family,

especially the safety of children, if you set the temperature exceeding 50°C, please

take care.