User guide

10
Directions for use
Caution: Before using the water heater, make sure that it should be filled with water and
the power plug has been connected properly.
Attention: When the water heater is installed in its place, connect the power supply after
waiting over 30 minutes initially.
1. Initial power
When the water heater power plug is connected for initial power
ON, the electronic controller will detect automatically. All screen
indicators will glow (Fig. 10) and go out seconds later indicating
the heater is standby.
2. Power ON/OFF
Press the ON/OFF key " ", the water heater is on. Firstly, the
electronic controller default state is at preset temperature mode
and default display time. Display the current clock "12:00",
Fig. 10
Hot Water
Quantity
Actual Temp.
Low
Set Temp.
Quick
Standard
Heat
Modes
MAX
kWh
Hot Water
Quantity
Override
Energy
meter
Timer 3
0
C
:
8888
Timer 2Timer 1Timer 3
MAX
Low
Timer ON
Timer OFF
0
C
Clock/
Timers
Fig. 9 Touch control panel functions
To set Clock and
ON/OFF timers (Timer l,
Timer ll, Timer l+ll).
upto 3
To display the total energy
consumption of the water
heater.
To set the Timer 3.
To get more hot water
continuously for longer
bathing time.
To start heating the water,
press ON/OFF key.
To decrease temperature,
clock, timers.
AES function adopts the
heating cycles to the
water utilisation habit.
To display the amount of
hot water in the tank by
changing green to red.
To change the three
different heating modes.
To increase temperature,
clock, timers.
To switch ON, the water
heater enters the heating
state instantly.
The LED displays working
states and setting changes
made on water heater.