User guide

Mounting guidelines

Drill two holes in 90 mm depth at least by using an electric impact drill with a ø10 mm bit.

The holes must be in level. Space between the two holes should be as shown in Fig. 2 based on

the model.

Fig. 2 Mounting distance of hangers

HSE-HNS-060

198mm

375mm

HSE-HNS-080

375mm

HSE-HNS-050

Fig. 3 Installation of mounting bracket Fig. 4 Mounting of the water heater

Wall

Fig. 5 Installation of mounting bracket

Caution: The provided mounting accessories can only be used for solid wall, as shown in

Fig. 5. Improper installation may cause the water heater to fall down.

Caution:

• Nylon expansion tube must pass through the hole of the mounting bracket first,

and then be inserted into the drilled holes.

• It is necessary to use special inner hexagon spanner to fasten the bolts into the

nylon expansion tubes, no other tools are permitted. During fastening of the

screws, ensure that the counter sunk head of the screw is not excessively tightened,

which may damage the nylon expansion tubes.

Proper

Improper

• Fix the hangers on the wall by using the inner hexagon spanner and expansion screws

(Fig. 3).

• Insert the square holes on the upper of supporting rack at the back of the water heater

into the hanger of the hanging plate, move down the water heater to ensure the square

holes against the root of the hanger. Confirm the reliable fixing of the water heater

(Fig. 4).