Installation Guide

35 Page
ADDITIONAL FEATURES
-Informaon mode-
You can get some information about the water heater condition by pressing the "INFO" button. For
more information, follow the procedures below:
INFO
Button
Operation
Screen on the controller
Built-in controller Remote controller
1st. press
Inlet water temperature will be displayed on
the remote controller by pressing the "INFO"
button.
2nd. press
Outlet water temperature will be displayed on
the remote controller by pressing the "INFO"
button.
3rd. press
Water flow will be displayed on the remote
controller by pressing the "INFO" button.
4th. press
Press the "INFO" button to finish information
mode.
Inlet water
temperature
Outlet water
temperature
Water flow
Normal Operaon
Owner's Guide
-Unit conversion mode-
Units of measure can be changed from Imperial to Metric and vice versa. For example, temperature can
be changed from °F to °C. Flow rate will also change from gallons per minute to liters per minute when
this setting is changed. Follow this procedure to change this setting:
Operation
Screen on the controller
Built-in controller Remote controller
1.
Press the "ON/OFF" button on the controller in
order to turn the controller on.
2.
When ON, the orange LED is lit.
3.
The previous set temperature will be displayed on
the screen.
4.
Press the "INFO" buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 100 °F)
(EX.: 38 °C)