Troubleshooting guide

5-4 Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems Reference and Installation Guide
)LJXUH 5HPRYLQJWK H&RPSXWHU&RYHU
5HSODFLQJWKH&R PSX WHU& RYHU
Use the following procedure to replace the computer cover:
 & KHFNDOOFDEOHFRQQHFWLRQVHVSHFLDOO\WKRVHWKDWPLJKW KDYHFRPH
ORRVHGXULQJ\RX UZRUN)ROGFDEOHVRXWR IWKHZ D\VR WKDWWKH\GR QRW
FDWFKRQWKHFRPSXWHUFR YHU0DNHVXUHFDEOHVDUHQRWURXWHGRY HUWKH
GULYHFDJH³WKH\ZLOOSUHYHQW W KHFRYHUI URPFOR VLQJSURSHUO\
  &KHFNWRVHHW KDWQRWRROVR UH[WUDSDUWVLQFOXGLQJVF UHZVDUHOHIW
LQVLGHW KHFRPSXWHU·VFKDVVLV
 5 HSODFHWKHFRYHU
From the front of the computer, hold the cover at about a 45-degree angle as
shown in Figure 5-3. Fit the three cover hooks into the rectangular slots on the
chassis. (It may be helpful to look down into the chassis to verify that the hooks
are in place.)
Pivot the cover down toward the back and into position. Make sure that the
securing buttons click into place.
NOTE: The computer should be placed fully on a flat surface. It is difficult to align
the cover if the front of the computer is hanging over the edge of a table.
securing buttons (2)
front of computer