Troubleshooting guide

Introduction 1-11
)LJXUH $WWDFKLQJWKH2SWLRQDO6WDQGIRU9HUWLFDO2ULHQWDWLRQ
As you lower the stand into place, make sure that the locator pin (see Figure 1-3)
fits into the corner hole of the hole pattern as shown. When the stand is in place,
tighten the thumbscrew.
 5 RWDWHWKHFRPSXW HUVRWKDWWKHVWDQGLVDWWKHERWWRPDQGWKHGULYHV
DUHDWWKHWRS
To remove the stand, turn the computer over so the stand is at the top, loosen the
screw and lift the stand away, and place the computer in a horizontal position.
(1(5 *<67$5

&RPSOLDQFH
Certain configurations of Dell computer systems comply with the requirements set
forth by the Environmental Protection Agency (EPA) for energy-efficient computers. If
the front panel of your computer bears the ENERGY STAR
®
Emblem (see Figure 1-4),
your original configuration complied with these requirements and all ENERGY STAR
®
power management features of the computer are enabled. To disable or change the
operation of these features, you must change the setting for the Power Management
category in the System Setup program. For instructions, see Chapter 2, “Using the
System Setup Program.”
NOTES: As an ENERGY STAR
®
Partner, Dell Computer Corporation has determined
that this product meets the Energy Star guidelines for energy efficiency.
Any Dell computer bearing the ENERGY STAR
®
Emblem is certified to comply with
EPA Energy Star requirements
as configured when shipped by Dell
. Any changes
you make to this configuration (such as installing additional expansion cards or drives)
locator pin
securing
button
captive screw