Troubleshooting guide
Installing Drives 7-9
5HFRQQHFW\RX UF RPSXW HUDQGSHULSKHUDOVWRDQHOHFW ULF DORXW OHWDQG
WXUQWKHP RQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
7R UHVHWWKHFKDVVLVLQWUXVLRQGHWHFWRU HQWHUWKH6\VWHP6HWXSSURJUDP
DQGUHVHW&KDVVLV,QWUXVLRQ WR1RW'HWHFWHG
See Chapter 2, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
8SGDWH\RXUV\VWHPFRQILJXUDWLRQLQIRUPDWLRQLQWKH6 \VWHP6HWXS
SURJUDP
For a diskette drive, update the appropriate Diskette Drive option (A or B) on
Page 1 of the System Setup screens to reflect the size and capacity of your new
diskette drive. (For more information, see Chapter 2, “Using the System Setup
Program.”)
If you installed a non-EIDE tape drive as the second drive, set the Diskette
Drive B option to Not Installed.
For EIDE CD-ROM and tape drives, set the appropriate Drive option (0 or 1)
under Drives: Secondary to Auto.
9HULI \WKDW\ R X UV\VWH PZ R UNVFR UU HFW O\
See your
Diagnostics and Troubleshooting Guide
for information on running the
Dell Diagnostics and troubleshooting any problems that may occur. Use the fol-
lowing guidelines to determine which test to use:
If you installed a diskette drive, test it by running all of the subtests in the
Diskette Drive(s) test group of the Dell Diagnostics.
If you installed a CD-ROM drive, see the documentation that came with the
drive for instructions on loading device drivers and using the drive. If it is an
EIDE CD-ROM drive, test it by running all of the subtests in the integrated
drive electronics (IDE) CD-ROM Drives test group of the Dell Diagnostics.
If you installed a tape drive, first verify that your diskette drive is still operat-
ing correctly by running all of the subtests in the Diskette Drive(s) test group
of the Dell Diagnostics. Then perform a tape backup and verification test
with the drive as instructed in the software documentation that came with
the tape drive.
NOTE: The tape drives sold by Dell come with their own operating software and
documentation. After you install a tape drive, refer to the documentation that
came with the drive for instructions on installing and using the tape drive
software.