Troubleshooting guide

7-8 Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems Reference and Installation Guide
)LJXUH $WWDFKLQJ'LVNHW WH7DSH'ULYHDQG'&3RZHU&DEOHV
 )RUDQ(,'(WDSHGULYHRU&'520GULYHFRQQHFWWKHRWKHUHQGRIWKH
LQWHUIDFHFDEOHW RWKHLQWHUIDFHFRQQHFWRUODEHOHG´,'(µRQWKHV\VWHP
ERDUG
For a diskette drive, connect the cable from the drive to the interface connector
labeled “DSKT” on the system board.
For a drive that comes with its own controller card, connect the other end of the
interface cable to the controller card.
Check all cable connections. Fold cables out of the way to provide airflow for the
fan and cooling vents.
  , IWKHLQF KGULY HED\ZDVSUHYLRXVO\HPSW\UHPRYHWKH IURQW
SDQHOLQVHUWIURPWKHFRPSXWHUFRYHU
See “Removing and Replacing Front-Panel Inserts” found earlier in this chapter.
 5HSODFHWKHFRPSXW HUFRYHU
If the bezel on your drive is not flush with the bezel on your computer, remove
the drive and adjust the position of the drive on the bracket, making sure to insert
and tighten the screws in the order marked. Replace the drive in the drive bay,
and then replace the computer cover.
diskette/tape
drive interface cable
DC power cable
interface connector
power input
connector