Specifications

ptg
63
Removing Material from a Sequence
4. Open the Magician B-roll bin, and load the Magician and Assistant clip
into the Source monitor.
The Magician and Assistant clip has one track of video (V1) and two
tracks of music (A1 and A2). For now, let’s edit only the video. (Later,
when editing with multiple audio tracks, you can edit music too.)
5. Select V1 and deselect A1 and A2 on the source side. Select V1 and
deselect A1 and A2 on the record side.
6. Mark an IN in the Source monitor where you want the edit to begin.
7. Mark an IN and an OUT in the sequence where you want the overwrit-
ten footage to go. (Be sure to place your IN and OUT marks on either
side of the edits where you extracted material.)
All audio tracks have been
deselected in this video-only edit
Marked portion will be overwritten
with source video
Extracted frames cause jump cuts in the
interview clip, but these will be covered up
by the resulting overwrite edit
Yo u n ow h av e t hre e m ark s: an I N and an O UT in t he se qu e nce an d
an IN in the source. You are ready to make a three-point edit.
8. Perform the overwrite by pressing the B key.
9. Continue making three-point edits as you go through the sequence,
matching video to the appropriate audio. You can use any of the B-roll
clips in the Magician B-roll bin. As you play through these clips, you
will notice that each clip corresponds to a part of the interview audio
that you’ve already edited. Get creative!
Download from www.wowebook.com