Specifications

ptg
346
Delivering the Finished Work
To resample the audio sample rate:
1. Right-click the sequence in the bin, and select Change Sample Rate.
2. From the Sample Rate menu, select the desired sample rate. You must
choose 48 kHz if you are going to a DV deck or using embedded SDI
SD or HD audio.
3. Set the Quality to High, and click OK.
New master clips and media are created for each converted clip.
Those clips already at the correct sample rate will remain unaffected.
Changing Audio and Video Output Options
Depending on your specific hardware configuration, you may need to con-
figure several more audio and video output settings.
If you want to output embedded SDI audio (using a single cable for audio
and video,) and your system has a hardware box that supports it, you need
to manually configure this capability.
Note that all embedded SDI audio is 24-bit. If you are recording embed-
ded SDI SD audio to a DigiBeta deck, you need to set the sample bit
depth to 24 bits. (If the deck supports only 20-bit resolution, the extra four
bits are ignored.)
To output embedded S D I audio:
1. Open the Audio Project settings.
2. Set Sample Bit Depth to 24 Bit.
3. To selec t S D S D I o r H D SD I audio, click the Outpu t ta b in the audio
project settings, and select SD SDI or HD SDI (the latter is available
only with HD project formats).
Download from www.wowebook.com