Specifications

ptg
108
Fine-Tuning the Sequence
3. To analy ze t he re sult of y our trim, you can loop the playb ack by repea t-
ing step 1.
This transition was trimmed 22 frames to the right. The 22 frames were added to the
A-side clip and removed from the B-side clip. The duration of the sequence and all
other clips remained the same.
Yo u c an a ls o t rim by dr ag g ing th e t ri m ro ll e rs i n t he Ti me li n e.
To trim by dragging the rollers:
1. Click one or more trim rollers in the Timeline, and then drag them
forward or back in the sequence. The pointer turns to a hand icon as
you drag.
If you are performing a single-roller trim, make sure that the Trim pointer
is pointed in the direction you want to trim.
2. Ctrl+drag (Windows) or Command+drag (Macintosh) to snap to an
IN or OUT mark, the previous or next edit point, or an edit point on
another track.
As you trim, the trim boxes display the number of frames that have
been trimmed from the outgoing and incoming sides of the transition.
Exiting Trim Mode
After you’ve performed your trim, you’ll want to exit Trim mode.
To exit Trim mode and return to Source/
Record mode, do one of the following:

Click the Source/Record Mode button at the bottom of the Timeline
palette or between the right and left Trim monitors.

Click anywhere in the timecode (TC1) track in the Timeline.

Click the Trim Mode button.

Click a Step Forward or Step Backward button below the Trim monitors.

Press a Step key (1, 2, 3, 4).

Press the Escape key.
Download from www.wowebook.com