Instruction manual

18
OPERATION
OSD ADJUST
Reset the operation panel to initial mode:

When turn off the OSD adjust in SD PREVIEW, output will show A/B-bus and output system information. As shown below.
INFORMATION
A INPUT: HDMI 1
SYSTEM: 1080i60
B INPUT: YPbPr 1
SYSTEM: 480p60
OUTPUT: NTSC F/W Version

When turn ON the function in OSD PREVIEW, output will show the adjust screen. As shown below.
MENU [1][2][3]
A PICTURE
CONTRAST [ 58]
BRIGHT [ 31]
COLOR [ 31]
HUE [ 31]
DETAIL [ 10]
ASPECT [FULL]
OSD adjustment function and range setting as below diagram:
CONTRAST [ 58 ] 0~63
BRIGHT [ 31 ] 0~63
[1] A PICTURE COLOR [ 31 ] 0~63
HUE [ 31 ] 0~63
DETAIL [ 10 ] 0~63
ASPECT [FULL] AUTO FULL 16:9 4:3
CONTRAST [ 58 ] 0~63
BRIGHT [ 31 ] 0~63
MENU [2] B PICTURE COLOR [ 31 ] 0~63
HUE [ 31 ] 0~63
DETAIL [ 10 ] 0~63
ASPECT [FULL] AUTO FULL 16:9 4:3
A AUDIO [AUTO] AUTO-CH1-CH2-CH3-CH4-CH5-CH6
B AUDIO [AUTO] AUTO-CH1-CH2-CH3-CH4-CH5-CH6
[3] SETUP VOLUME [ 127 ] 0~127
LIP SYNC [33MS] 0~170
OUTPUT [NTSC] NTSC-NTSC 43-PAL-PAL M-PAL N
DEFAULT SECAM-480p60-576p50-720p50-720p60-1080i50-1080i60

When in MENU mode, press

◄

► to adjust the page. Press

▼ and

▲ to select
the functions; once the functions are selected press

◄ and

► to adjust the values.
NOTE: The values are not saved to the unit’s memory until you exit the OSD ADJUST mode.
When the unit is turned off the system will change the value back to its default value. Press
ADJUST

to exit the OSD adjust screen and the system will automatically save to the memory.