Instruction manual

17
OPERATION
AUTO FADE/WIPE SELECTION
Reset the operation panel to initial mode:

→
Press the ON button to enter into AUTO FADE/WIPE mode.

→
FADE/WIPE transition time can be adjusted with the TIME control

.

→
Press the WIPE button

to select the wipe effect.

→
Press the MIX button

to select MIX (FADE) effect.

→
Press the START button

to start Auto wipe or fade effect.
NOTE: When in AUTO FADE/WIPE mode the Video Slider

is disabled.
DIGITAL EFFECT
Digital effect section which generates digital special effects for the A-bus and B-bus source
video signals. The selected effect(s) can be added to either the A-bus or B-bus at one time.
NOTE: The mosaic effect is not available in the picture-in-picture frame in PIP mode.

/

A-bus, B-bus digital effect ON button.

/

STILL button - creates a still frame.

/

PAINT button - creates a ‘paint’ effect. Repeatedly pressing the PAINT button will
cycle through (3) levels of the effect.

/

NEGATIVE button - creates a negative image.

/

MOSAIC button - creates a ‘pixillated’ effect. Repeatedly pressing the MOSAIC button will cycle through (3) levels of the effect.
AUDIO MIXER
The Audio can be controlled either separately or in
combination with a video source.

When the AUDIO FOLLOW’s LED illuminate the Audio
may be adjust by Video slider

along with the video.
When the LED is off the Audio will be adjusted by

and

buttons.

Adjusts the A-bus source’s audio level.

Adjusts the B-bus source’s audio level.

AUX: Controls the audio level of the auxiliary input.

MIC: Controls the audio level of the microphone input.