Instruction manual

16
OPERATION
KEY
Reset the operation panel to initial mode:
How to use the LUMA KEY effect:

→
Press the KEY button

to place the unit in KEY mode.

→
Press one of the A-bus selection buttons to select a source.

→
Press one of the B-bus selection buttons to select a source.

→
Press the LUMA KEY button

. The darker areas of the picture will become transparent and allow the image of the other source
to show through.

→
Use the Video Slider

to control the LUMA KEY level.

→
Press button

or

to change the source that is being keyed.

→
Press the LUMA KEY

again to reverse the LUMA KEY effect.
How to use the BLUE KEY effect:

→
Press the KEY button

to place the unit in KEY mode.

→
Press one of the A-bus selection buttons to select a source.

→
Press one of the B-bus selection buttons to select a source.

→
Press the BLUE KEY button

. The blue areas of the picture will become transparent and allow the image of the other source to
show through.

→
Use the Video Slider

to control the LUMA KEY level.

→
Press button

or

to change the source that is being keyed.

→
Press the Blue KEY

again to reverse the BLUE KEY effect.