Instruction manual

RS-232 Control

Remote Command System from a Personal Computer

The ANI-MOD Matrix series can be controlled remotely from a personal computer. The control signal is brought into the ANI-MOD Matrix

through the RS-232 connector on the back panel of the unit. The commands are input through software that comes with the ANI-MOD

Matrix, once installed in the computer.

RS-232 Cable Pins Used

Communications Protocol:

1. Transmission Rate: 9600 bps

2. Data Format: 8 data bits, No parity , 1 start bit, and 1 stop bit

3. Flowing Control: None

Also known as: 9600,8,n,1

Proper settings for the computer’s communication protocol are shown in the screen shots below:

A NEUVIDEO