Instruction manual
11
CHANGEABLE CARDS
HDBaseT™ Card
ANI-IN-HDBT-4K & ANI-OUT-HDBT-4K
Input Output
Input (4) RJ45 Output (4) RJ45
Input Connector Female RJ45 / 3.5mm mini jack for IR
(3) poles captive screw connector
for RS-232
Output Connector Female RJ45 / 3.5mm mini jack for IR
(3) poles captive screw connector
for RS-232
Input Impedance 75Ω Output Impedance 75Ω
General
Gain 0dB ~ 10dB@100MHz Bandwidth 6.75Gbps
Resolution Range 800x600 ~ 1920x1200 Transmission Distance 70M(Max)
SNR >70dB@ 100MHz-100M Return Loss <-30dB@ 5KHz
THD < 0.005%@1KHz Min. ~ Max. Level < 0.3V ~ 1.45Vp-p
HDMI Standard Support HDMI1.4 and HDCP Differential Phasic Error ±10° @ 135MHz_100M
• Supports hot-plug, HDTV, compatible with HDBaseT™ 1.0, HDMI 1.4a & HDCP 1.4
• Wide resolution range from 480p to 4K2K, 1080p 3D compliant
• Extends HDBaseT™ signal up to 70M at 1080p or 40M at 4K2K
• Bi-directional RS-232 transmission on single cable
• Auxiliary audio ports support stereo signal
• Embedded EDID management technology
ANI-IN-HDBT-4K: Is an input card which accepts a maximum of input (4) separate HDMI signals. Input signals can be passed to output
devices through ANI-OUT-HDBT-4K, or pass through to other types of output cards in the series. This card needs to work in conjunction
with an ANI-402T HDBaseT™ Transmitter*.
ANI-OUT-HDBT-4K: Is an output card which provides a maximum of (4) separate output signals. Input signals can come from ANI-IN-
HDBT-4K, or from other kinds of input cards in the series. This card needs to work in conjunction with an ANI-402R HDBaseT™ Receiver*.
Provision is made within the card for passing RS-232 and IR over the same CAT5e/6 (or better) cable. These are specic to the HDBaseT™
channel. They do not have to be used for the HDBaseT™ channel to function, but are provided for those situations where they are
needed. Please note that this is separate of the RS-232 and IR channels that are provided for the ANI-MOD Matrix unit’s controls.
Pin layout of the RJ45 connectors: (2) different connection standards can be chosen; connectors on both ends of the same cable should
use the same standard.
TIA/EIA T568A TIA/EIA T568B
PIN CABLE COLOR PIN CABLE COLOR
1 green white 1 orange white
2 green 2 orange
3 orange white 3 green white
4 blue 4 blue
5 blue white 5 blue white
6 orange 6 green
7 brown white 7 brown white
8 brown 8 brown
*For more information on the ANI-402T and ANI-402R please see our website.
A NEUVIDEO
When using STP, Cable
connectors MUST be
metal, and the shielded
layer of cable MUST
be connected to the
connector’s metal
shell, to well share the
grounding.