Instruction manual

RS-232 & TELNET COMMANDS

All commands require a carriage return (0x0D). Commands are case-sensitive.

Command Action ANI-QUAD Returns

AUA001 Dual A Audio channel in Left side AUA001

AUA002 Dual A Audio channel in Right side AUA002

AUA999 Check Dual A audio channel status AUA???

AUB001 Dual B Audio channel in Left side AUB001

AUB002 Dual B Audio channel in Right side AUB002

AUB999 Check Dual B audio channel status AUB???

AUD000 Audio output Off AUD000

AUD001 Audio output On AUD001

AUD999 Check audio on/off status AUD???

AUE000 Audio EDID is LPCM 2CH AUE000

AUE001 Audio EDID is LPCM 6CH AUE001

AUE002 Audio EDID is LPCM 8CH AUE002

AUE003 Audio EDID is BITSTREAM AUE003

AUE004 Audio EDID is HD AUE004

AUE999 Check audio EDID setting AUE???

BEZ000 Bezel Correction OFF BEZ000

BEZ001 Bezel Correction ON BEZ001

BEZ999 Check bezel correction on/off status BEZ???

BEH??? Horizontal (H) Bezel correction???=000 ~ Maximum BEH???

BEH998 Check the current Horizontal(H) Bezel correction Maximum value BEH???

BEH999 Check the current Horizontal(H) Bezel correction setting value BEH???

BEV??? Vertical (V) Bezel correction???=000 ~ Maximum BEV???

BEV998 Check the current Vertical(V) Bezel correction Maximum value BEV???

BEV999 Check the current Vertical(V) Bezel correction setting value BEV???

BRI??? Setting Brightness No response

???=000~100 for matrix mode

???=(000~100)+200*(OUT No.-1) for dual/Video Wall mode

For example: OUT B set the Brightness value to 57 =(57)+200*(2-1) = 257

BRI99? Check current Brightness value BRI???

99?=999 for matrix mode

99?=991~994=OUT1~4 for dual/Video Wall mode

CAL??? RECALL FAV. ???=001~004=FAV.1~4 CAL???

CON??? Setting Contrast No response

CON999 Command setting same as Brightness(BRI) CON???

EGW999 RS-232 only, check current Ethernet Gateway Address aaa.bbb.ccc.ddd

EIP999 RS-232 only, check current Ethernet IP Address aaa.bbb.ccc.ddd

EMK999 RS-232 only, check current Ethernet Subnet Mask Address aaa.bbb.ccc.ddd

HUE??? Setting HUE No response

HUE999 Command setting same as Brightness (BRI) HUE???

INP??? INPUT selection???=001~004=IN 1~4 INP???

Execute OUT???