Instruction manual
REMOTE CONTROL
REMOTE CONTROL
REMOTE CONTROL DIP SWITCH RS-232 PROTOCOLS
Open Remote control back cover to adjust dip-switch ON/OFF
to match IR address setting in the OSD menu. Factory default
is “0”.
6
q
Power: Press this button to switch On the device or press it again
to set it to standby mode.
w
Info: Press this button to show the device’s rmware version.
e
Out A~D and In 1~4: Press out-put A~D and then press input1~4
to select display input.
For example: press Out A then press In 1, output A will display input
1’s image.
r
MATRIX/DUAL/WALL: Press to switch between Matrix mode,
Dual mode and Video Wall mode.
t
Lock: Press once to lock the keypad and remote control. Press
and hold for 3 seconds to release the lock function.
y
Mute: Press this button to mute the audio from HDMI output port.
u
▲/▼/←/→/OK: Press these buttons to scroll through the OSD
selection and press OK to enter and conrm the setting.
i
Exit: Press this button to exit the OSD menu or the OSD settings.
o
Menu: Press this button to enter into the OSD menu.
a
1024x768/720p/1080p: Press these hot keys to switch between
each resolution.
s
AL/AR/BL/BR: When in Dual mode, press these hot keys to
switch the audio channel in Left or Right side for Dual A and Dual B
group.
d
SAVE: To save the customized input and output settings.
• Press “Matrix/Dual/Wall” button to select mode status.
• Press each output channel A~D and then press
corresponding input channel 1~4.
• Press “SAVE”, then input 1~4’s LED will illuminate at the
same time, then press remote control FAV.1~FAV.4 to save
to the system memory.
f
FAV.1~FAV.4: Press favorite hot keys 1~4 to bring up the
customized settings you previously stored.
Remote Controller(PC)
PIN Denition
1 NC
2 RxD
3 TxD
4 NC
5 GND
6 NC
7 NC
8 NC
9 NC
Baud Rate: 115200bps Data Bit: 8 bits Flow Control: None
Parity: None Stop Bit: 1
ANI-QUAD
PIN Assignment
1 NC
2 TxD
3 RxD
4 NC
5 GND
6 NC
7 NC
8 NC
9 NC