Instruction manual

PANEL DESCRIPTIONS
REAR PANEL
q
HDMI IN 1~4: Connect HDMI source signal such as STP, DVD player, Blue-ray player, or PC.
w
HDMI OUT 1~4: Connect HDMI destination device such as a Monitor, Recorder, or distribution system.
e
Ethernet: Connect to an active Ethernet network for telnet control (refer to section “RS-232 / telnet Commands”)
r
USB SERVICE ONLY: This slot is reserved for factory use and rmware updates.
t
RS-232: Used for remote control of the ANI-QUAD using RS-232 commands via a PC or other external controller.
y
DC 12V: Plug the 12V DC power supply into the unit and connect the adaptor to an AC outlet.
4